TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 208 of 1616

TM 9-2320-440-13&P

0024-6

0024

NO HIGH IDLE DURING MRP ELEVATION OPERATION OVER 5 DEGREES (CONTINUED)

THAAD0539

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

NOTE

Relay 10 has to be partially removed to perform Step 8.

Step 8.

Install relay 10 (TM 9-2320-325-14&P). Turn engine start switch ON

(

Select N (neutral) on transmission range selector

(

Position LHS cab control mode select switch to MRP position

(WP 0007). With jumperwires installed in THAAD chassis harness MUJB connector per

Step 1, check for continuity from ECU vehicle/selector harness relay 10 connector,

terminal 30 to a known good ground, when deck elevation controls are operated

(WP 0007).

If there is no continuity, replace relay 10 (TM 9-2320-325-14&P).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

TM 9-2320-347-10)

TM 9-2320-347-10)