TM-9-2330-202-13-P
TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
DECEMBER 2011
TM-9-2330-202-13-P - Page 294 of 552
REAR SPRING HANGER INSTALLATION
1.
If removed, install bushing (Figure 5, Item 2) in rear spring hanger (Figure 5, Item 1).
1
2
M116_M101_4-95A
Figure 5.
Bushing Installation.
2.
Install rear spring hanger (Figure 6, Item 10) on frame (Figure 6, Item 1) with four cap screws
(Figure 6, Item 9), washers (Figure 6, Item 2), and new self-locking nuts (Figure 6, Item 3). Torque self-locking
nuts (Figure 6, Item 3) to 30 lb-ft (41 N•m).
3.
Use lifting device to raise vehicle until shackle (Figure 6, Item 6) is aligned with rear spring hanger
(Figure 6, Item 10).
4.
Install shackle pin (Figure 6, Item 7) through shackle (Figure 6, Item 6) and rear spring hanger
(Figure 6, Item 10).
5.
Install slotted nut (Figure 6, Item 5) on shackle (Figure 6, Item 6) and tighten. Install new cotter pin
(Figure 6, Item 4) on shackle (Figure 6, Item 6).
6.
Install new lubrication fitting (Figure 6, Item 8) in shackle pin (Figure 6, Item 7).
7.
Remove support from rear corner of vehicle. Remove lifting device from under vehicle.
1
2
2
3
3
4
5
6
7
8
9
10
M116_M101_4-94A
Figure 6.
Rear Spring Hanger Installation.
END OF TASK
TM 9-2330-202-13&P
0058
0058-6
Back to Top
