TM-9-2330-202-13-P
TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
DECEMBER 2011
TM-9-2330-202-13-P - Page 301 of 552
FIELD MAINTENANCE
DRAWBAR REPLACEMENT
INITIAL SETUP:
Tools and Special Tools
Tool Kit, General Mechanic's
(WP
0115, Table 1, Item 1)
Wrench, Torque (WP
0115, Table 1, Item 2)
Wrench, Torque (WP
0115, Table 1, Item 3)
Materials/Parts
Self-locking nut (WP
0097, Figure 16, Item 1)
Self-locking nut (WP
0097, Figure 16, Item 4)
References
WP
0072
Equipment Condition
Hydraulic brake actuator assembly removed
(as applicable) (WP
0050)
Equipment Condition (cont.)
Fixed front support leg removed
(as applicable) (WP
0062)
Intervehicular cable removed from roadside
drawbar (WP
0041)
Chassis wiring harness removed from roadside
drawbar, if removing roadside
drawbar (WP
0040)
Hydraulic brake lines removed from
curbside drawbar, if removing curbside
drawbar (WP
0052)
WARNING
Trailer must be supported by blocking or support stands placed under axle or frame
throughout maintenance procedure. Failure to comply may result in death or injury to
personnel. Seek medical attention in the event of an injury.
NOTE
The procedure for removing and installing drawbars is the same for roadside and curbside.
REMOVAL
1.
Raise trailer and place suitable support at rear corners and at midpoint of vehicle.
TM 9-2330-202-13&P
0061
0061-1
Back to Top
