TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 110 of 576
TM 9-2330-227-14&P
WALL RECEPTACLES AND BASE, 11O-VOLT
This task covers:
a. Removal (page 4-32)
b. Installation (page 4-33)
INITIAL SETUP
Tools
Tools - Continued
Drill, electric, portable, 1/2-inch
Screwdriver, cross-tip, number two
Drill, twist, 3/16-inch
Screwdriver, flat-tip, 3/16-inch
Hacksaw, hand
Hammer, hand, ball-peen
Personnel Required
Pliers, diagonal cutting
One
ACTION
LOCATION
ITEM
REMARKS
WARNIN G
Contact with live 110-volt electrical wires could result in serious injury or death. Make
sure power source is disconnected before performing maintenance on the electrical
system.
NOT E
All wall receptacles and bases are removed and installed the same way. This task is for
one section; repeat for the others.
REMOVAL
1.
2.
3.
4.
Base (1)
Two covers (2)
Using 3/16-inch flat-tip screwdriver,
pry off.
NOT E
Tag wires to aid in installation (page 4-4). If circuit marker bands are missing or not
readable, replace (page 4-73).
Wall
Screw (4)
Using 3/16-inch flat-tip screwdriver,
receptacle (3)
unscrew one-quarter turn.
Wall receptacle (3)
Take off.
and two wires (5)
Wall
Two contact
a. Using 3/16-inch flat-tip screwdriver
receptacle (3)
screws (6) and
unscrew screws (6) part way
two wires (5)
b. Pull wires (5) off screws (6).
4-32
Back to Top
