TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 154 of 576

TM 9-2330-227-14&P

CONNECTOR RECEPTACLE, 24-VOLT - CONTINUED

INSTALLATION - CONTINUED

TASK ENDS HERE

CONNECTOR RECEPTACLE, 110-VOLT

This task covers:

a. Removal (page 4-76)

b. installation (page 4-77)

INITIAL SETUP

Tools

Personnel Required

Handle, ratchet, 1/2-inch drive

One

Screwdriver, flat-tip, 3/16-inch

Socket, 1/2-inch drive, 1/2-inch

ACTION

LOCATION

ITEM

REMARKS

WARNIN G

Contact with live 110-volt electrical wires could result in serious injury or death. Make

sure power source is disconnected before performing maintenance on the electrical

system.

REMOVAL

1.

Connector

Four screws (2)

Using 1/2-inch socket and ratchet handle,

receptacle (1)

and Iockwashers (3)

unscrew and take out.

2.

Outside front

Connector

Pull away from wall just far enough to

wall (4)

receptacle (1)

reach behind with 3/16-inch flat-tip

screwdriver.

NOT E

Tag wires to aid in installation (page 4-4). If circuit marker bands are missing or not

readable, replace (page 4-66).

3.

Connector

Two screws (5)

Using 3/16-inch flat-tip screwdriver,

receptacle (1)

unscrew part way.

4.

Connector

Two wires (6)

a. Pull out wires (6).

recptacle (1) and

b. Take off receptacle (1).

wire harness (7)

4-76