TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 280 of 576

TM 9-2330-227-14&P

WIRE HARNESS, 110-VOLT, CONNECTOR RECEPTACLE-TO-MAIN CIRCUIT BREAKER

This task covers:

a. Removal (page 5-6)

b. Installation (page 5-6)

INITIAL SETUP

Tools

Personnel Required

Handle, ratchet, 3/8-inch drive

One

Screwdriver, flat-tip, 3/8-inch

Socket, 3/8-inch drive, 1/2-inch

Equipment Condition

Socket, 3/8-inch drive, 7/16-inch

Connector receptacle, 110-volt, removed

(page 4-76).

Insulation removed as required to access

harness (page 4-173).

ACTION

LOCATION

ITEM

REMARKS

REMOVAL

1.

Inside front

Harness (2)

Pull through.

wall (1)

2.

Two clamps (3)

Two screws (4) and

Using 3/8-inch flat-tip screwdriver,

nuts (5)

7/16-inch socket, and ratchet handle with

3/8-inch drive, unscrew and take off.

3.

Harness (2)

Two clamps (3)

Using 3/8-inch flat-tip screwdriver,

spread and take off.

4.

Frame (6)

Harness (2)

Take off.

INSTALLATION

5.

6.

Harness (2)

7.

Two clamps (3)

Harness (2)

Place in position.

Two clamps (3)

a. Put in position.

b. Put on harness (2).

Two screws (4) and

Screw together, and tighten using 3/8-inch

nuts (5)

flat-tip screwdriver, 7/16-inch socket,

and ratchet handle with 3/8-inch drive.

5-6