TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 288 of 576
5-14
TM 9-2330-227-14&P
WIRE HARNESS, 24 - VOLT, RUNNING LIGHTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
NOT E
Some semitrailers may have side clearance lights only.
2.
Four clamps (1)
at right front
corner (2)
Four screws (3)
and nuts (4)
Using 3/16-inch flat-tip screwdriver
and 7/16-inch box-end wrench,
unscrew and take out.
Using 3/16-inch flat-tip screwdriver,
spread and take off.
Using diagonal cutting pliers, cut at
floor level and pull out.
Repeat steps 2, 3, and 4 at left
front corner.
Using 3/16-inch flat-tip screwdriver
and 7/16-inch box-end wrench,
unscrew and take out.
Using 3/16-inch flat-tip screwdriver,
spread and take off.
Using diagonal cutting pliers, cut at
floor level and pull out.
Repeat steps 5, 6, and 7 at right
rear corner.
Pull apart.
3.
Harness branch (5)
Four clamps (1)
Harness branch (5)
5.
Four clamps (1)
at left rear
corner (2)
Four screws (3)
and nuts (4)
6.
Harness
branch (5)
Four clamps (1)
7.
Harness branch (5)
Right tail-
light (6)
Three
connectors (7)
Blackout stop-
light (8)
Connector (9)
Pull apart.
Left tail-
light (10)
Three
connectors (7)
Pull apart.
11.
11 clamps (11)
underside of
11 screws (13)
a. Using number two cross-tip
screwdriver, unscrew and take out,
b. Mark location of screws.
Using 3/16-inch flat-tip screwdriver,
spread and take off.
floor (12)
11 clamps (11)
12.
Harnes s
branch (5)
Back to Top
