TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 296 of 576
TM 9-2330-227-14&P
WIRE HARNESS, 24-VOLT, RUNNING LIGHTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
63.
Wire (1) and
Two grommets (4)
harness branches
(2) and (3)
64.
Frame rail (5)
Two grommets (4)
65.
Right rear
Wire (1) and
corner (6)
harness branch (2)
66.
Wire (1) and
Four clamps (7)
harness branch (2)
67.
Left rear
Harness branch (3)
corner (8)
66.
Harness
Four clamps (7)
branch (3)
69.
Eight clamps (7)
Eight screws (9)
and nuts (10)
70.
Left front
Three connector
clearance
halves (12)
Iights (11)
5-22
Put on.
Using 3/16-inch flat-tip screwdriver,
push in.
Place in position.
Put on.
Place in position.
Put on.
Screw in, and tighten using 3/16-inch
flat-tip screwdriver and 7/16-inch
box-end wrench.
Match wire numbers, and connect together.
Repeat this step on remaining
clearance and identification lights.
Back to Top
