TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 287 of 576
TM 9-2330-227-14&P
WIRE HARNESS, 24- VOLT, RUNNING LIGHTS
This task covers:
a. Removal (page 5-13)
b. Installation (page 5-18)
INITIAL SETUP
Tools
Personnel Required
Pliers, diagonal cutting
One
Screwdriver, cross-tip, number two
Screwdriver, flat-tip, 3/16-inch
Equipment Condition
Wrench, box-end, 7/16-inch
Connector receptacle removed (page 4-74).
Materials/Parts
Insulation removed as required to get
to harness (page 4-173).
Wire, safety (item 22, appendix E)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOT E
The 24-volt wire harness is disconnected from all service, clearance, and identification
lights the same way. Repeat this procedure for others.
Tag wires to aid in installation (page 4-4). If circuit marker bands are missing or not
readable, replace (page 4-73).
1.
Harness (1) to
Three connectors (3)
Pull apart.
clearance
lights (2)
5-13
Back to Top
