TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 284 of 576

5-10

TM 9-2330-227-14&P

CONNECTOR RECEPTACLE REPAIR, 24-VOLT - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

REPAIR - CONTINUED

3.

Continued

4.

Bushing (3) and

12 wires (2)

retaining nut (4)

5.

Bushing (3)

12 wires (2)

b. Using soldering iron, heat insert (1)

and pull from wires (2).

Pull out.

6.

12 wires (2)

12 inserts (1)

Make sure wire ends are clean before soldering, If necessary, clean with cleaning

solvent and stiff fiber brush. Solder must be non-acid type; use rosin flux. Wires

and soldering iron must be pre-tinned for good connection and maximum transfer of

heat. After soldering, clean all solder joints with an acid swabbing brush and alcohol.

7.

Bushing (3)

12 wires (2)

and inserts (1)

a. Position wires in bushing according

to chart (5).

b. Push all the way through.

c. Using wire stripper, strip insulation

back 1/4-inch.

Slip an insert over each wire, and solder

using non-acid solder and soldering iron.

NOT E

Push wire and inserts into bushing

until inserts are seated.

8.

Shell (6)

Bushing (3)

9.

Bushing retaining

nut (4)

Put in place.

Screw on, and tighten.