TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 175 of 640
0030-3/(4 blank)
TM 9-2330-335-14&P
0030
INSTALLATION
00030
NOTE
Excess wire is stored in left-front underside pocket (refer to WP 0041, Figure 1) for M871R.
Excess wire is stored in receptacle converter box compartment (refer to WP 0028, Figure 1) for
M871A1R. Excess wire is stored in nose plate box compartment (refer to WP 0029, Figure 1) for
M871A2R.
1.
Replace any damaged grommets (Figure 1, Items 11 thru 13), as necessary.
NOTE
Use dielectric grease on all pins.
2.
Install BO socket wiring harness (Figure 1, Item 6) and main wiring harness (Figure 1, Item 10).
3.
Install two PL10 marker wiring harnesses (Figure 1, Item 8) to BO socket wiring harness (Figure 1, Item 6).
4.
Install two PL10 wiring harnesses (Figure 1, Item 9) to two front marker lights and two PL10 marker wiring harnesses
(Figure 1, Item 8).
5.
Install midturn ABS wiring harness (Figure 1, Item 7) to two midside clearance lights and main wiring harness
(Figure 1, Item 10).
6.
Install ABS main wiring harness (Figure 1, Item 5) to ABS warning light, rear wiring harness (Figure 1, Item 4), and main
wiring harness (Figure 1, Item 10).
7.
Install wiring harness (Figure 1, Item 3) to rear clearance lights and rear wiring harness (Figure 1, Item 4).
8.
Install wiring harness (Figure 1, Item 2) to two BO lights and BO light wiring harness (Figure 1, Item 6).
9.
Install two wiring harnesses (Figure 1, Item 1) to taillights, side clearance lights, and rear wiring harness
(Figure 1, Item 4).
END OF TASK
FOLLOW-ON TASKS
00030
1.
Connect semitrailer to prime mover.
2.
Raise landing legs.
3.
Remove/store chocks and ground boards.
4.
Check to ensure lighting system is operational.
END OF TASK
END OF WORK PACKAGE
Back to Top
