TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 439 of 1348

Table

1.

FIELD LEVEL PMCS - SEMI-ANNUAL - Continued.

ITEM

NO.

INTERVAL

ITEM TO BE

CHECKED OR

SERVICED

PROCEDURE

EQUIPMENT

NOT READY/

AVAILABLE IF:

17

Semi-

Annual

Front

Suspension Pins

NOTE

•

If an air-operated grease gun does

not purge the fitting, use a hand-

operated grease gun. If the part does

not purge, remove fitting and clean,

install fitting and grease again. If part

still does not purge, refer to

maintenance task for that

component.

•

When using a grease gun, apply

lubricant to the fitting until clean

lubricant squeezes out of the part

being lubricated.

•

If suspension pin does not accept

grease, relieve load on suspension

pin by jacking trailer up by frame as

close to suspension pin as possible.

•

If suspension pin still fails to accept

grease, notify supervisor to remove

suspension pin and/or bushing and

replace if necessary.

Lubricate all suspension pins with GAA (WP

0193,

Table 1, Item 33, 34, 35, 36, 37) every 3,000 mi (4,828

km) or semi-annually, whichever comes first.

Fittings will not purge old

lubricant out of

component.

TM 9-2330-342-23&P

0047

0047-9