TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 511 of 1348

REMOVAL - Continued

9.

Remove two nuts (Figure 3, Item 9), lockwashers (Figure 3, Item 8), washers (Figure 3, Item 7), and mounts

(Figure 3, Item 6) from frame (Figure 3, Item 1). Discard lockwashers.

END OF TASK

INSTALLATION

NOTE

•

If only replacing LED, perform Steps (7) through (9).

•

To properly secure bracket, it may be necessary to tighten upper and lower nuts at

the same time.

•

All three lights are installed the same way.

•

Replace cable ties as required.

1.

Install two mounts (Figure 4, Item 6) on frame (Figure 4, Item 1) with two washers (Figure 4, Item 7),

lockwashers (Figure 4, Item 8), and nuts (Figure 4, Item 9).

1

2

3

4

5

6

9

8

7

Figure 4.

Rear Center LED Marker Lights/Bracket Installation.

2.

Position bracket (Figure 4, Item 2) on two mounts (Figure 4, Item 6).

3.

Install two washers (Figure 4, Item 5), lockwashers (Figure 4, Item 4), and nuts (Figure 4, Item 3) on mounts

(Figure 4, Item 6).

NOTE

Ground wire 1435 (Figure 5, Item 4) only installed on center light.

4.

Install gasket (Figure 5, Item 6) and mounting base (Figure 5, Item 10) on bracket (Figure 5, Item 5) with screw

(Figure 5, Item 9) and locknut (Figure 5, Item 1).

TM 9-2330-342-23&P

0057

0057-3