TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 1137 of 1364

TM 9-2350-238-20-1

2-196. MAINTENANCE OF CRANE OPERATOR’S ENCLOSURE KIT.

This task covers:

a.

Installation

c. Testing

b.

lnspection/Repair

d.

Removal

INITIAL SETUP

Tools and Special Tools

References

Automotive maintenance and repair shop

TM 9-2350-238-24P-I

equipment: organizational maintenance,

common no. 2 (less power) (item 81,

General Safety Instructions

appx B)

Drill

Drill bits

Tap

Failure to remove or disconnect

Torque wrench (0 to 200 in.-lb)

batteries before removing or

installing any electrical wiring

Materials/Parts

harness or lead may result in

Adhesive (item 5, appx C)

injury or damaged equipment.

Antiseize compound (item 6, appx C)

Cutting fluid (item 15, appx C)

Dry cleaning solvent (SD2) is

Dry cleaning solvent (item 16, appx C)

toxic and flammable. Wear pro-

Liquid soap (item 42, appx C)

tective goggles and gloves and

Sealant (item 36, appx C)

use only in a well-ventilated

area.

Failure to remove or disconnect batteries before removing or installing any electrical

wiring harness or lead may result in injury or damaged equipment.

NOTE

The crane operator’s enclosure kit must be disassembled before it is installed for the

first time.

1

Check to ensure that all kit parts are present and free of damage.

2-1111