TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 1143 of 1364

TM 9-2350-238-20-1
22
23
24
Install two window assembly chains (8) on
two base links (9).
Open vehicular window (12).
Peel back a portion of operator's cupola
ring cushioning pad (26) and drill a 1/2-in.
(12.70-mm) hole through its underside.
25
26
27
28
Dry cleaning solvent (SD2) is toxic
and flammable. Wear protective
goggles and gloves and use only in
well-ventilated area.
Using dry cleaning solvent, remove
adhesive residue from underside of
operator’s cupola (16).
Clean operator's cupola ring cushioning
pad (26) with liquid soap and water.
Insert circuit breaker to wiper motor and
defroster switch electrical lead assembly
(27) through the 1/2-in. (12.70-mm) hole
and into the notch in the cupola (16).
Install loop clamp (6), machine screw (5),
and self-locking nut (4) on crane
operator's base assembly (7).
2-1117


Back to Top