TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 57 of 1364
TM 9-2350-238-20-1
Table 2-2. PREVENTIVE MAINTENANCE CHECKS AND SERVICES WITH LUBRICATION
INSTRUCTIONS FOR M578 RECOVERY VEHICLE (CONT)
Item
No.
16
Interval
S
Item To Check/
Service
Final Drive
Drain and Fill
Procedure
a.
b.
c.
d.
e.
f.
Oil will be hot after operation.
NOTE
Drain only after operation.
Remove level plug (1) and drain plug
drain oil into a suitable container.
(2) and
Dry cleaning solvent (SD2) is toxic and
flammable. Wear protective goggles and
gloves and use only in well-ventilated area.
Clean drain plug with dry cleaning solvent (item
16, appx C) and install.
Remove fill plug (3) in final drive saddIe (left and
right sides).
Slowly add OE/HDO or OEA (item 28 or 29,
appx C) through fill plug hole (3) until oil flows
from level plug hole (1).
Clean plugs (1) and (3) with dry cleaning solvent
(item 16, appx C) and install.
Repeat steps for other side.
Not Fully Mission
Capable If:
Class Ill leaks
2-31
Back to Top
