TM-9-2350-238-34-2
CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
APRIL 1992
TM-9-2350-238-34-2 - Page 32 of 327
TM 9-2350-238-34-2
8 Paint metal surfaces after repair as required. Sand and paint damaged areas. Apply one coat of
rust inhibitor primer (item 17, appx B). Allow primer to dry for 30 minutes minimum before ap-
plying enamel. Paint with enamel to match existing color; use white enamel (item 7, appx B) or
olive drab enamel (item 6, appx B).
2-15. LUBRICATION.
Keep a light coat of lubricating oil (item 15, appx B) on parts during repair
procedures to prevent rusting. Lubricate parts during repair and assembly as required by TM 9-2350-238-
10 and TM 9-2350-238-20-2.
2-16. PAINTING INSTRUCTIONS.
Complete painting is authorized for and done by general sup-
port maintenance personnel or higher. Spot painting and restenciling vehicle markings is done by
unit maintenance personnel. Instructions for materiel preparation, priming, and finish are given in
TM 43-0139.
2-17. NONSKID AREAS.
Nonslip paint (item 16, appx B) will be used to coat deck areas where personnel walk. The areas to
be coated with nonslip paint are shown shaded in the figures below.
I
Change 1
2-19
Back to Top
