TM-9-2350-238-34-2
CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
APRIL 1992
TM-9-2350-238-34-2 - Page 38 of 327
TM 9-2350-238 -34-2
INSPECTION/REPAIR
1 Inspect for broken, damaged, or missing parts.
2 If level wind housing is broken, damaged, or missing, repair is by replacement of next
higher assembly.
3 Repair is by replacement of authorized parts (TM 9-2350-238-24P-2).
REASSEMBLY
1
2
3
4
5
6
7
8
9
10
If removed, install three new inserts (1)
to level wind housing (2).
Install lubrication fitting (3) to level wind
housing (2).
Install two sleeve bearings (4) to level
wind housing (2).
Install level wind bracket (5), three hex-
agon head capscrews (6), three flat
washers (7), three new Iockwashers (8),
and three nuts (9) to level wind housing
(2).
Install two electrical shells (10), two
bushing sleeve insulators (11), and two
female terminal assemblies (12) to each
of two level wind sensing push switches
(13).
Install two level wind sensing push swit-
ches (13) with attached parts to level
wind bracket (5),
Install sleeve bushing (14), quick release
pin (15), chain assembly (16), new Iock-
washer (17), and machine screw (18) to
cable guide (19).
Install two needle roller bearings (20),
two thrust washer bearings (21), and
cable guide (19) to level wind housing
(2).
Install helical spring (22), sleeve spacer
(23), and manual control lever (24) to
shaft of cable guide (19).
Using hammer and punch, install spring
pin (25) to secure manual control lever
(24).
2-25
Back to Top
