TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 367 of 772

TM 9-2350-260-20-1-2

AIR CLEANER REPLACEMENT (TOP LOADING) (Sheet 6 of 8)

NOTE

If you are installing an aluminum air cleaner, do steps 3, 4, and 6, then go to steps

10 and 11.

If you are installing an armored air cleaner, go to step 7.

3.

Before installing aluminum air cleaner, apply primer (Item 49, Appendix D) and locking compound (Item 18,

Appendix D) t screw threads, lockwashers, and washers.

4.

Using 5/8 inch socket, install six screws (A), washers (B), and washers (C) to secure air cleaner.

Do not overtighten

(crews must be torqued in following step).

5.

Using 5/8 inch socket, torque wrench, and extension, tighten six screws (A) to 2230 lb-ft (30-40 N

•

m).

6.

If gap shows between air cleaner mounting flange and outrigger fender, remove screws and use washers (C) to fill

gap and perform step 4 again.

NOTE

Use up to three washers (C) (as shims) for each bolt, if necessary, to fill gap.

7.

Before installing armored air cleaner, apply primer

(Item 49, Appendix D) and locking compound

(Item 18, Appendix D) to threads of nuts and bolts

and to washers.

8.

Using 5/8 inch socket install six bolts (D), washes

(F), new lockwashers (E) and nuts (G).

9.

Using torque wrench and 5/8 inch socket, tighten

six bolts (D) 85 to 95 lb-ft (115-129 N

•

m).

Go on to Sheet 7

TA148173

7-98