TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 567 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR FILTER ELEMENT REPLACEMENT (Sheet 3 of 6)

NOTE

Do not remove or otherwise disturb

the center element during outer filter

element replacement unless all three

elements

are

scheduled

for

replacement.

7.

Using hands, remove two outer filter elements (J)

by turning slightly and lifting out.

Throw away

filters.

8.

Remove center filter element (K) in same manner

as outer filters, if required.

CLEANING AND INSPECTION:

NOTE

Take care when cleaning inside of

fuel-water separator not to damage

any internal parts.

1.

Using dry cleaning solvent (Item 54, Appendix D)

and rags, clean inside of fuel-water separator.

2.

Inspect fuel-water separator for cracks or

fractures.

Inspect interior for scores and burrs.

3.

Using dry cleaning solvent and crocus cloth (Item

14, Appendix D), remove minor burrs and scores.

If cracked, excessively burred, or scored, contact

your supervisor.

4.

Flush with dry cleaning solvent.

INSTALLATION:

1.

Remove

container

from

under

fuel-water

separator.

2.

Remove rag from fuel outlet line (A).

3.

Using 7/8 inch wrench, install fuel outlet line (A) to

elbow (B).

Go on to Sheet 4

TA148373

7-298