TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 562 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 6 of 8)

CAUTION

Be careful not to strike ends of

sensors

during

installation

or

damage may result.

NOTE

Straight edge of mounting plate (G)

must be installed to the right against

the fuel-water separator.

5.

Manually conned solenoid valve electrical lead (D)

to fuel-water separator control assembly (A).

6.

Manually connect engine electrical harness

connector (E) to fuel-water separator control

assembly (A).

7.

Using screwdriver, install two screws and two

cushioned clamps (F) and mounting plate (G) at

right side and above fuel-water separator control

assembly.

8.

Using 9/16 inch wrench, install lower (shorter)

sensor (H) to fuel-water separator filter.

9.

Using 9/16 inch wrench, install upper (longer)

sensor (J) to fuel-water separator filter.

Go on to Sheet 7

TA148368

7-293