TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 564 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 8 of 8)

3.

Set MASTER CONTROL switch to ON (TM 9-

2350-260-10).

Watch fuel-water separator bleed

cap (A) for air release (bubbles).

4.

Set MASTER CONTROL switch to OFF (TM 9-

2350-260-10).

After about one minute, repeat

step 3.

NOTE

It may be necessary to perform steps

4 and 5 several times until a constant

fuel flow (no bubbles) from the bleed

cap (A) is observed.

5.

Check for leaks and tighten or replace component as necessary.

6.

Using 7/16 inch wrench, turn fuel-water separator bleed cap (A) to the right until snug.

7.

Perform operational check of automatic drain (page 7-245).

8.

Set FUEL PUMPS switch to OFF (TM 9-2350-260-10).

9.

Set MASTER CONTROL switch to OFF (TM 9-2350-260-10).

10.

Disconnect engine from powerplant ground hop (page 5-67).

11.

Install powerplant (page 5-40).

End of Task

TA148370

7-295