TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 559 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 3 of 8)

8.

Using 1/2 inch socket and extension, remove three

capscrews, lockwashers, flat washers (D), and

clamp (E).

Throw lockwashers away.

9.

Using 1/2 inch socket and extension, loosen

capscrew (F) to provide movement to fuel-water

separator filter.

NOTE

If adapters turn while removing

sensors, use 1/2 inch wrench to hold

them in place.

10.

Using 9/16 inch wrench, remove upper sensor (G)

from fuel-water separator filter.

NOTE

It may be necessary to use hammer

and punch to unseat sensors (G) and

(H) by tapping upward on the edge of

the sensor retaining nut.

11.

Using 9/16 inch wrench, remove lower sensor (H) fuel-water separator filter.

Go on to Sheet 4

TA148365

7-290