TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 560 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 4 of 8)

12.

Using screwdriver, remove two screws and two

cushioned clamps J) and mounting plate (K) at

right side and above fuel-water separator control

assembly (L).

NOTE

It may be necessary to use pliers to

start removal of connectors in steps

13 and 14.

13.

Manually disconnect engine electrical harness

connector (M) from fuel-water separator control

assembly (L).

14.

Manually disconnect solenoid valve electrical lead

(N) from fuel-water separator control assembly (L).

15.

Using 5/16 inch wrench, remove screw and

cushioned amp (P) holding solenoid valve

electrical lead (N) to fuel-water separator control

assembly (L).

16.

Using 5/16 inch wrench, remove three remaining

screws and washers (Q) holding fuel-water

separator control assembly (L) to mounting plate.

Remove control assembly.

Go on to Sheet 5

TA148366

7-291