TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 648 of 772

TM 9-2350-260-20-1-2
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 4 of 8)
19.
Insert 1/8 inch diameter pin (R) through alinement
hole of lever assembly (S).
If locating pin (R)
cannot be inserted, perform steps 20 thru 25.
If
locating pin can be inserted, go to step 25.
20.
Using pliers, remove two cotter pins and pins (T).
Throw cotter pins away.
21.
Using 1/2 inch wrench to hold each clevis (U), use
1/2 inch wrench to loosen each nut (V).
22.
Position lever assembly (S) so that locating pin (R)
can be inserted.
23.
Turn two clevises (U) until two pins (T) slip freely
into lever assembly (S).
Using pliers, install two
new cotter pins through pins (T).
24.
Using 1/2 inch wrench to hold each clevis (U), use
1/2 inch wrench to tighten each nut (V).
25.
Remove locating pin (R).
Go on to Sheet 5
TA148454
7-379


Back to Top