TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 649 of 772

TM 9-2350-260-20-1-2

ACCELERATOR LINKAGE ADJUSTMENT (Sheet 5 of 8)

26.

Traverse turret to position gun tube to front for access to engine compartment (TM 9-2350-260-10).

27.

Insert 1/8 inch diameter locating pin (W) through

alinement hole of remote control lever (X).

If

locating pin cannot be inserted, perform steps 28

through 34.

If locating pin can be inserted, go to

step 34.

28.

Using 7/16 inch wrench to hold rod end bearing

(Y) (on flats), use 1/2 inch wrench to loosen nut

(Z).

29.

Using 7/16 inch wrench, remove screw (AA).

30.

Insert locating pin (W) through alinement hole into

housing (AB).

NOTE

If rod (Y) cannot be adjusted short

enough for screw (AA) to slip freely

through lever (X) push rod (Y)

forward and insert screw (AA).

31.

Turn rod end bearing (Y) until screw (AA) slips

freely through remote control lever (X) and rod

end bearing.

32.

Using 7/16 inch wrench to hold rod end bearing

(Y), tighten nut (Z).

33.

Using 7/16 inch wrench, tighten screw (AA).

34.

Remove locating pin (W).

Go on to Sheet 6

TA148455

7-380