TM 9-2350-260-20-1-2
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 2 of 8)
ADJUSTMENT’
1.
Open turret platform access door and traverse
turret to position gun tube over right front fender
stowage box (TM 9-2350-260-10).
2.
Check to see that threaded shaft (A) is flush with
inside of clevis (B) at location (C).
If threaded
shaft is flush, go to step 6.
If threaded shaft is not
flush, go to steps 3, 4, and 5.
3.
Using pliers, remove cotter pin (D) and pin (E).
Throw cotter pin away.
4.
Using 9/16 inch wrench to hold clevis (B), use 1/2
inch wrench to loosen nut (F) and adjust clevis (B)
so that shaft is flush with clevis.
5.
Using 9/16 inch wrench to hold clevis (B), use 1/2
inch wrench to tighten nut (F).
6.
Insert 1/16 inch diameter pin at location (G) in rod
end bearing (H) to be sure that threads of tube
assembly (J) go into rod end bearing beyond
location (G).
If tube assembly is not inserted
beyond location (G), go to steps 7 and 8.
If tube
assembly is inserted beyond location (G), go to
step 9.
7.
Using 7/16 inch wrench to hold (on flats) rod end
bearing (H) and 1/2 inch wrench to loosen nut (K),
adjust rod end bearing as stated in step 6.
8.
Using 7/16 inch wrench to hold (on flab) rod end
bearing (H), use 1/2 inch wrench to tighten nut (K).
NOTE
Rod (H) or clevis (B) may be pulled in
order to insert pin (E).
9.
Insert pin (E) and, using pliers, install new cotter
pin (D).
Go on to Sheet 3
TA148452
7-377