TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 651 of 772

TM 9-2350-260-20-1-2
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 7 of 8)
43.
Stop engine (TM 9-2350-260-10).
44.
Insert either end of go/nogo gage (AB) between
stop pin (AF) and bracket (AG).
Hold in this
position while person in driver's station presses
pedal to full throttle position.
45.
With pedal in full throttle position, screw (AH) must
contact floor and stop pin must contact either end
of go/no-go gage (AB).
If this requirement cannot
be met, do steps 46 thru 48.
If requirement is met,
go to step 49.
46.
Using two 9/16 inch wrenches, loosen jamnut (AJ)
and screw (AH) on back side of accelerator pedal
(AK).
47.
Using two 9/16 inch wrenches, hold screw (AH)
and tighten jamnut (AJ).
Go on to Sheet 8
TA148457
7-382


Back to Top