TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 720 of 772

TM 9-860-260-20-1-2

TURBOCHARGER SHROUDS REPLACEMENT (Sheet 6 of 6)

Upper Shroud Replacement (Sheet 1 of 1)

TOOLS:

1/2 in. combination box and open end wrench

1/2 in. socket with 1/2 in. drive

5 in. extension with 1/2 in. drive

Ratchet with 1/2 in. drive

SUPPLIES:

Self-locking nut (MS21045-16)

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-1)

Remove engine shroud (page 9-2)

Remove rear engine shroud support (page 9-4)

NOTE

Procedures for replacement of the left or right turbocharger shrouds are similar.

Procedures for the left side are shown.

REMOVAL:

1

Using 1/2 inch socket with extension and 1/2 inch wrench, remove bolt and self-locking nut (A).

Throw self-locking

nut (A) away.

2.

Using 1/2 inch socket, remove three bolts (B).

3.

Remove upper shroud (C).

INSTALLATION:

1.

Position upper shroud (C) in place.

2.

Install three bolts (B).

3.

Install bolts and new self-locking nut (A).

4.

Using 1/2 inch socket with extension and 1/2 inch wrench, tighten bolts (A) and (B).

5.

Install rear engine shroud support (page 9-5).

6.

Install engine shroud (page 9-3).

7.

Install 2A powerplant (page 5-14) or 2D powerplant (page 5-40).

End of Task

TA146864

9-18