TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 719 of 772

TM 9-2350-260-20-1-2

TURBOCHARGER SHROUDS REPLACEMENT (Sheet 5 of 6)

Outer Shroud Replacement (Sheet 1 of 1)

TOOLS:

1/2 in. combination box and open end wrench

1/2 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

SUPPLIES:

Self-locking nut (503345) (4 required)

PRELIMINARY PROCEDURE:

Remove powerplant (page 5-1)

REMOVAL:

NOTE

Procedures for replacement of the left or right turbocharger shrouds are similar.

Procedures for the left side are shown.

1.

Using 1/2 inch socket and 1/2 inch wrench,

remove four screws and self-locking nuts (A)

securing outer shroud (B).

Throw self-locking nut

away.

2.

Remove outer shroud (B).

INSTALLATION:

1.

Position outer shroud (B) to turbocharger.

2.

Install four screws and self-locking nut (A) to secure outer shroud (B) to turbocharger.

3.

Using 1/2 inch socket and 1/2 inch wrench, tighten screws and self-locking nuts (A).

4.

Install 2A powerplant (page 5-14) or 2D powerplant (page 540).

End of Task

TA146863

9-17