TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 107 of 783

TM 9-2350-260-20-1-3

MASTER CONTROL PANEL REPAIR (Sheet 33 of 71)

Bilge Pump Switch and Indicator Light Replacement (Sheet 1 of 4)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

10-95

Installation

10-97

TOOLS:

Flat-tip screwdriver

Cross-tip screwdriver

SUPPLIES:

Silicone compound (Item 32, Appendix D)

Preformed packing (7358626)

Lockwasher (MS35338-42) (4 required)

PRELIMINARY PROCEDURE:

Remove panel from tank (page 10-54)

NOTE

This procedure to be used only if bilge pump switch and indicator light are present

on master control panel.

REMOVAL:

1.

Using

finger,

remove

lens

(A)

by

turning

counterclockwise.

2.

Remove preformed packing (B).

Throw preformed

packing away.

3.

Using fingers, disconnect electrical connector (C)

from base assembly (D).

4.

Using screwdriver, remove two screws (E) and

lockwashers (F) securing base assembly (D) to

panel.

Throw lockwashers away.

5.

Remove base assembly (D).

6.

Using fingers, remove lamp (G) from base assembly

(D).

Go on to Sheet 2

TA147127

10-95