TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 33 of 783
TM 9-2350-260-20-1-3
GENERATOR REPLACEMENT (Sheet 15 of 15)
30. Using 9/16 inch wrench, install washer (AV), ground strap (U), flat washer (AU), and new self-locking nut (AW) to
terminal (AX).
31. Using 9/16 inch wrench, install electrical lead (circuit 530), electrical lead (circuit 415), electrical lead (circuit 2), flat
washer (AY) and new self-locking nut (AZ) to terminal (BA).
32. Using 3/8 inch wrench, install electrical lead (circuit 1), flat washer (BB) and new self-locking nut (BC) to terminal
(AS).
33. Using 3/8 inch wrench, install electrical lead (circuit 478), flat washer (BD), and new self-locking nut (BE) to terminal
(AT).
34. Connect engine for powerplant test run (page 5-54).
35. Start and run engine at idle speed according to procedures for powerplant test run (page 5-57).
36. Check BATTERY-GENERATOR indicator in driver's compartment for proper indication.
37. Shut down and disconnect engine as prepared for powerplant test run (ground hop) (page 5-67).
38. Install 2A powerplant (page 5-14) or 2D powerplant (5-40).
End of Task
TA147053
10-21
Back to Top
