TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 41 of 783
TM 9-2350-260-20-1-3
STARTER REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
10-30
Installation
10-30
TOOLS:
Diagonal cutting pliers
1/2 in.
combination box and
Flat-tip screwdriver
open end wrench
Slip joint pliers
3/4 in.
combination box and
Ratchet with 1/2 in.
drive
open end wrench
10 in.
extension with 1/2 in.
drive
13/16 in.
combination box and
1/2 in.
socket with 1/2 in.
drive
open end wrench
3/4 in.
socket with 3/8 in.
drive
15/16 in.
combination box and
9/16 in.
socket with 1/2 in.
drive
open end wrench
3/4 in.
socket with 1/2 in.
drive
Torque wrench with 3/8 in.
drive
(0-200 lb-in.)
SPECIAL TOOLS:
Ground hop kit (Item 30, Chapter 3, Section I)
Wrench, open end (Item 4, Chapter 3, Section I)
SUPPLIES:
Pencil
Lockwasher (MS45904-76)
Two tags
Self-locking nut (MS21044N5) (2 required)
Lockwire (10 in.) (Item 59, Appendix D)
Lockwasher (MS35333-40) (4 required)
Glyptol (Item 38, Appendix D)
Self-locking nut (MS21044N10) (3 required)
PERSONNEL:
Two
REFERENCES:TM 9-2350-260-10
PRELIMINARY PROCEDURES:Remove powerplant (page 5-1)
Remove starter low voltage relay solenoid (page 10-36)
(2D engine only)
Go on to Sheet 2
10-29
Back to Top
