TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 46 of 783
TM 9-2350-260-20-1-3
STARTER REPLACEMENT (Sheet 6 of 7)
5.
Slide starter cradle assembly bracket (E) into
position on starter (C).
6.
Using fingers, install three screws (F) with flat
washers to secure starter cradle assembly
bracket (E) to engine oil pan (G).
NOTE
When
installing
double-braided
ground strap (H) to screw (J), make
sure flat washer seats flat against
bracket face.
7.
Using fingers, install double-braided ground strap (H) with screw and fat washer (J), and install screw to starter cradle
assembly bracket (E) and engine oil pan (G) as in step 6.
8.
Using 1/2 inch wrench, tighten two new self-locking
nuts evenly to be sure nuts and U-bolts seat
properly.
9.
Using 9/16 inch socket and extension, secure four
screws and flat washers (F) and (J).
NOTE
After securing bolts and flat washers
(F) and (J) check front of starter case
to be sure there is no gap between
starter case and support cradle
assembly.
If there is a gap, loosen
bolts (F) and (J) and adjust position
of cradle assembly so there is no
gap.
10. Using 1/2 inch socket and extension, secure low voltage relay solenoid bracket (L) to engine oil pan (G) with four
screws (M) and new lockwashers (N).
Go on to Sheet 7
TA147066
10-34
Back to Top
