TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 44 of 783
TM 9-2350-260-20-1-3
STARTER REPLACEMENT (Sheet 4 of 7)
NOTE
The top and front fasteners have
bolts (Y) which pass through the
engine hull housing (AA) and must be
held in place when removing the self-
locking nuts (Z).
The inboard
fastener has a stud and will not
require a wrench to hold it in place.
10. Using 15/16 inch wrench on bolts (Y) and special
wrench (Item 4, Chapter 3, Section I) on self-locking
nuts (Z), loosen and remove three self-locking nuts
(Z) securing tarter (F) to starter drive adapter (AB).
Throw self-locking nuts away.
11. Using two persons, ease starter out of starter drive adapter (AB).
Remove starter from engine.
12. Remove gasket (AC) from starter drive adapter (AB).
Throw gasket away.
Go on to Sheet 5
TA147064
10-32
Back to Top
