TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 356 of 783

TM 9-2350-260-20-1-3

ENGINE WIRING HARNESS REPLACEMENT (2A ENGINE)(Sheet 8 of 13)

INSTALLATION:

1.

Position engine wiring harness (A) onto engine, through grommet (B) in shroud, and onto transmission.

2.

Position cable connector (C) onto bracket (D).

3.

Using screwdriver and 3/8 inch wrench, install and tighten four screws (E), new lockwashers (F), and nuts (G) to

secure connector (C) and ground lead (H) to bracket (D).

4.

Install harness (A) cable into clamps (J).

5.

Using two 7/16 inch wrenches, install and tighten screws (K), lockwashers (L) and nuts (M), securing clamps (J) to

brackets (N).

Go on to Sheet 9

TA147376

10-344