TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 627 of 783

TM 9-2350-260-20-1-3

ROADWHEEL ARM REPLACEMENT (Sheet 4 of 7)

6.

If roadwheel arm does not come out of support

housing (D) after repeated hits with slide hammer,

perform steps 7, 8, and 9.

7.

Screw two 5/8-13 UNC threaded screws into two

retaining jackscrew holes.

8.

Using 5/8 inch socket, alternately and evenly tighten

jackscrews.

9.

Use slide hammer (F) while tightening jackscrews, if

used, to free arm from support housing (D).

10. When arm is loose in support housing (D), remove

slide hammer (F) and adapter (E).

11. Using another person, remove roadwheel arm and

gasket to clean working area.

Throw gasket away.

12. Using internal puller (G), remove inner grease seal

(H) from support housing (D).

Throw seal away.

13. Cover up opening in roadwheel support housing so

dirt will not get into housing (D).

Go on to Sheet 5

TA147806

14-5