TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 629 of 783

TM 9-2350-260-20-1-3

ROADWHEEL ARM REPLACEMENT (Sheet 6 of 7)

1.

Remove covering from roadwheel support housing

opening.

2.

Apply a light coat of grease (Item 37, Appendix D) to

outer edge of new inner grease seal.

3.

Position inner grease seal (A) into roadwheel

housing (B) opening so BACK of seal (A) goes in

towards hull.

You should be able to see FRONT of

seal (A) as you look into housing.

4.

Using oil seal replacer and handle (Items 20 and 9,

Chapter 3, Section I), tap lightly on handle with

hammer until inner seal has bottomed in housing

(B).

5.

Coat all parts on upper spindle (C) with grease (Item

37, Appendix D).

6.

Install new gasket (D) to mounting face of retainer

(E).

NOTE

Upper spindle (C) must be properly

alined with support housing (B) while

roadwheel arm (F) is being installed.

CAUTION

Do not use excessive force while

installing roadwheel arm; damage to

seal may result.

7.

Using two persons, install upper spindle (C)

completely into support housing (B).

Go on to Sheet 7

TA147808

14-7