TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 635 of 783

TM 9-2350-260-20-1-3

ROADWHEEL ARM REPAIR (Sheet 5 of 6)

1.

Coat outer edge of seal with grease (Item 36,

Appendix D).

2.

Position seal (A) into retainer with front of seal facing

upward.

3.

Using replacer and handle, tap handle with hammer

to install seal (A).

4.

Install oil seal replacer (Item 20, Chapter 3, Section

I) to face with spacer on upper spindle of arm.

5.

Position retainer (B) onto upper spindle.

6.

Make sure seal in retainer (B) fits into open end of

deflector on roadwheel arm.

NOTE

Keep bearing halves together as a set when installing

outboard and inboard bearings (C) and (D).

7.

Coat inner and outer races of outboard bearings (C) with grease (Item 36, Appendix D).

Install inner race on spindle.

Install outer race over it.

Go on to Sheet 6

TA147814

14-13