TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 640 of 783

TM 9-2350-260-20-1-3

HUB ASSEMBLY REPLACEMENT (Sheet 4 of 7)

4.

Inspect bearings and cups for damage.

Replace as

necessary.

5.

Check seal assembly for rust, missing rivets, or

other damage.

Replace seal as required.

ASSEMBLY:

1.

Grease (Item 36, Appendix D) both bearing cups.

Position remover-replacer tool (Item 18, Chapter 3,

Section I) to inner cup (A) in hub (B).

2.

Using hammer, tap remover-replacer to seat inner

cup (A) into place in hub (B).

3.

Using other remover-replacer tool (Item 15, Chapter

3, Section I) with hammer, repeat steps 1 and 2 to

seat outer cup (C) in hub (B).

6.

Inspect all nuts, washers, and screws for wear and

damaged threads.

7.

Inspect spacer on spindle for scratches, nicks, or

dents.

If damaged, notify support maintenance.

Go on to Sheet 5

TA147819

14-18