TM 9-2350-260-20-1-3
HUB ASSEMBLY REPLACEMENT (Sheet 3 of 7)
13. Position remover-replacer (Item 15, Chapter 3,
Section I) onto inner edge of outer bearing cup (W)
in hub (L).
14. Using hammer, tap handle to drive outer bearing cup
(W) from hub (L).
15. Repeat steps 13 thru 14 to remove inner bearing
cup (X) from hub (L), using other remover - replacer
tool (Item 16, Chapter 3, Section I).
CLEANING AND INSPECTION:
1.
Clean all parts including bearings.
2.
Inspect hub and cover plate for cracks or damage.
There should be no cracks.
3.
Minor nicks, scratches, gouges, and pitting are okay
if they are not on machined surfaces.
Go on to Sheet 4
TA147818
14-17