TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 636 of 783

TM 9-2350-260-20-1-3

ROADWHEEL ARM REPAIR (Sheet 6 of 6)

8.

Apply grease (Item 36, Appendix D) to bearing spacer (E) and bearing washer (F).

9.

Install bearing spacer (E) onto spindle up against outboard bearing (C).

10. Repeat step 7 to install inboard bearings (D).

11. Install key washer (G) on spindle of arm so that inside tab fits into groove.

NOTE

Make sure outer tabs of key washer are pointing towards nut (H).

12. Screw nut (H) onto threaded end of spindle.

13. Using spindle nut wrench (Item 27, Chapter 3,

Section I), tighten nut (H) until parts on spindle

cannot be turned by hand.

14. Back off nut (H) just enough so parts can be turned

by hand through one complete turn on spindle.

15. Using pliers, bend tab on key washer (G) into alining

slot on nut (H).

16. Install roadwheel arm (page 14-6).

End of Task

TA147815

14-14