TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

  TM-9-2350-260-20-1-3 - Page 637 of 783

TM 9-2350-260-20-1-3
HUB ASSEMBLY REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Disassembly
14-15
Cleaning and Inspection
14-17
Assembly
14-18
TOOLS: 9/16 in. socket with 1/2 in. drive
Drift punch
Ratchet with 1/2 in. drive
Hammer
Hinged handle with 1/2 in. drive
Long round nose pliers
2 1/2 in. socket with 3/4 in. drive
Ratchet with 3/4 in. drive
Pinch bar
Torque wrench with 3/4 in. drive (0-600 lb-ft)(0-814 N
m)
SPECIAL TOOLS: Replacer (Item 20, Chapter 3, Section I)
Spanner wrench (Item 27, Chapter 3, Section I)
Handle (Item 10, Chapter 3, Section I)
Remover-replacer (Item 16, Chapter 3, Section I)
Remover-replacer (Item 15, Chapter 3, Section I)
SUPPLIES: Grease (Item 37, Appendix D)
Gaskets
Seal
Preformed packing
Bearing nut lock
Lockwashers (MS35338-65)(12 required)
REFERENCE: LO 9-2350-260-12
PRELIMINARY PROCEDURE: Remove roadwheels (page 14-51)
DISASSEMBLY:
1.
Using 9/16 inch socket, remove six screws (A),
lockwasher (B), and washers (C).
Throw
lockwashers (B) away.
2.
Remove cover plate (D) and gasket (E).
Throw
gasket away.
Go on to Sheet 2
TA147816
14-15


Back to Top