TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

  TM-9-2350-260-20-1-3 - Page 632 of 783

TM 9-2350-260-20-1-3
ROADWHEEL ARM REPAIR (Sheet 2 of 6)
DISASSEMBLY:
1.
Using pliers, bend key washer tabs back out of slot
in nut.
2.
Using spindle nut wrench (Item 27, Chapter 3,
Section I), loosen nut (A).
Remove nut.
3.
Remove key washer (B) and bearing washer (C).
Throw bearing washer away.
NOTE
Keep inner and outer races of bearings together as matched set.
If you throw away
one race, throw away other one.
4.
Use sleeve spacer (D) like a slide hammer to loosen inboard bearing (E).
Remove bearing.
5.
Remove sleeve spacer (D) and outboard bearing (F).
6.
Pull oil seal retainer (G) off upper spindle (H).
Go on to Sheet 3
TA147811
14-10


Back to Top