TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 648 of 783

TM 9-2350-260-20-1-3

SUSPENSION TORSION BAR REPLACEMENT (Sheet 3 of 7)

8.

Using crowbar (or pinch bar), apply upward force to

bottom of roadwheel arm (F).

9.

Have second person position blocks under arm (F)

while force is being applied.

10. Remove crowbar.

11. Using automotive wrench, screw special adapter

(Item 6, Chapter 3, Section I) into threaded hole of

torsion bar (E).

NOTE

Adapter must be tightened after each

striking movement.

12. Using slide hammer puller (Item 12, Chapter 3,

Section I) with adapter, strike torsion bar (E) with

slide hammer by sliding slide hammer puller along

slide hammer rod.

13. Keep on striking torsion bar (E) with slide hammer.

Hammer with some force until torsion bar (E) spline

is free from side of hull.

14. Pull bar (E) out of support arm (F).

Go on to Sheet 4

TA147827

14-26