TM 9-2350-260-20-1-3
TORSION BAR ANCHOR REPLACEMENT (Sheet 2 of 3)
4.
Separate anchor (F) from cover (C).
5.
If pins (G) must be removed from cover, using drill,
make 1/4 inch hole in top of pin.
6.
Using extractor tool, remove pins (G) from cover.
7.
There are 12 covers and anchors on tank (one for
each torsion bar).
8.
Remove them, as necessary, to repair suspension
system.
INSTALLATION:
1.
Press two pins (A) into cover (B), if they were
removed.
2.
Install gasket (C) to cover (B).
Go on to Sheet 3
TA147833
14-32