TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 662 of 783

TM 9-2350-260-20-1-3

TRACK SUPPORT ROLLER REPLACEMENT (Sheet 7 of 11)

INSTALLATION:

1.

Aline hole in axle (A) with hole in housing when

mounting axle.

2.

On left front support roller ONLY, using hammer,

drive two new spring pins through housing into axle

(one from each side).

3.

Continue driving spring pins (B) in until they are both flush (even) with housing surface, as shown.

4.

Position dome of both plugs (C) to outside.

Using hammer and 3/4 inch punch, drive plugs into place (both sides).

5.

When plugs are fully seated, using hammer and 3/16 inch alining punch, force edges of dome into hull housing (this is

called 'dimpling').

Go on to Sheet 8

TA147841

14-40