TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 666 of 783

TM 9-2350-260-20-1-3

TRACK SUPPORT ROLLER REPLACEMENT (Sheet 11 of 11)

28. Place static ground spring (W) into access cover

plate (X) so tang is in hole inside cover plate.

29. Twist spring (W) into place.

30. Position new gasket (Y) and cover (X) to hub and

secure to hub with six new lockwashers (Z), flat

washers (AA), and screw (AB).

31. Using 9/16 inch socket, tighten screws alternately.

32. Using grease gun to lube fitting on cover plate, lube

roadwheel (LO 9-2350-260-12).

33. If jack was used, lower it.

Remove jack and planks (or plates).

34. Have second person start engine and move tank so two centerguides can be installed (TM 9-2350-260-12).

35. Install centerguides (TM 9-2350-260-10).

36. Test drive tank a short way (TM 9-2350-260-10).

37. Adjust track tension (TM 9-2350-260-10).

End of Task

TA147845

14-44