TM 9-2350-260-20-1-3
TRACK SUPPORT ROLLER REPLACEMENT (Sheet 10 of 11)
18. Install lock (M) and aline hole in lock (M) to dowel of
nut (L).
NOTE
If hole in lock (M) does not line up to dowel
of nut (L) turn lock over for closer alinement.
19. Install new nut lock (N) onto axle (A).
20. Make sure detent of nut lock (N) seats in hole of lock
(M).
21. Install hex nut (P).
Using 2-1/2 inch socket, tighten nut.
22. Using hammer and screwdriver, bend nut lock (N) around hex nut (P).
23. Grease seal (Q) with grease (Item 36, Appendix D).
24. Install seal (Q) to axle outer end with lip facing out.
25. Install new gasket (R) to drive cup (S).
26. Push drive key shaft (T) through cup (S) and install new cotter pin (U) with pliers.
27. Install speedometer drive assembly (V) through seal (Q) and into axle (A).
Rotate shaft (T) until splines on its end
mate to keyway in hull mounted adapter.
Go on to Sheet 11
TA147844
14-43