TM 9-2350-260-20-1-3
TRACK SUPPORT ROLLER REPLACEMENT (Sheet 9 of 11)
12. Position inner bearing (H) to support roller assembly
(K).
13. Have second person position support roller (K) and
inner bearing (H) on support axle.
14. Install outs bearing cone (J) into position on axle.
15. Screw round nut (L) onto shaft.
Using special
spanner wrench (Item 27, Chapter 3, Section I),
tighten round nut (L).
16. Loosen round nut (L) about 1/2 turn so support roller
(K) turns easily.
17. Rotate support roller (K) while retightening nut (L)
until bearings bind.
Back nut off 1/4 turn.
Go on to Sheet 10
TA147843
14-42